X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: Culbrz on May 13, 2010, 11:01:15 AM
-
I am using three camera with Vanguard. I have the VA11A and the VR31A. I get the same picture in Vanguard even though the camera are pointing different directions. Each power source is set differently. The first time I turned it on I saw three different views, then as I double clicked on each view the picture changed to the first view (A1).
Any help???
-
Did you get anything else in the kit?
Like a CM19A USB Interface to send and receive X10 RF signals. Along with a TM751 to transceive the signal to the power line? So the power supplies to each camera can be controlled.