X10 Community Forum

💬General Category => General Discussion => Topic started by: KenWong on June 11, 2009, 09:36:45 PM

Title: Write a Macro command to repeat sending an On signal until the mod turns on
Post by: KenWong on June 11, 2009, 09:36:45 PM

I guess due to noise on my lines, I need to repeat sending a command several times before a module will turn on.  This feature is available when you want to set a timer.

How do you write a macro that will continue to send an "On" signal to a module when it might not get the first or subsequent signals due to line noise?

Much Thanks

Ken

Title: Re: Write a Macro command to repeat sending an On signal until the mod turns on
Post by: Knightrider on June 11, 2009, 09:41:52 PM

How will AHPro (anagram for Oprah) recognize the module's status?  Many modules do not confirm or deny status to the controller.  The one's that do require a status request from said controller.