X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: Drews on April 27, 2007, 09:13:22 PM

Title: Macro on sensor to select camera not working right.
Post by: Drews on April 27, 2007, 09:13:22 PM

I have a macro on motion sensor C2 that activates a macros that selects Camera B2. I can see in the 'room' that the motion sensor in fact activates the macro. However the macro doesn't switch cameras. If I click on the macro to activate it it will in fact switch cameras. What's up with that?

Title: Re: Macro on sensor to select camera not working right.
Post by: Puck on August 15, 2007, 11:36:20 AM

Quote from: Drews on April 27, 2007, 09:13:22 PM

...However the macro doesn't switch cameras. If I click on the macro to activate it it will in fact switch cameras. What's up with that?

Clicking on a macro bypasses all set conditions. When a macro works manually but not when triggered (e.g. via motion sensor), it usually indicates a set condition has not been met.