Yes, I know it is well documented that they turn themselves on...
I have a fairly large project that is about to go down the toilet if I cannot get one site under control. I have looked for source of noise... nada. I have used various different modules (all WS467) to no avail. I have implemented the 10k resister accross the unused legs of the IC. I have also cut local control without success. At this point it looks like 90% of the wall switches work fine and reliably but this ONE location is going to be the one that breaks the bank.
Can anyone suggest a different device... needs to fit into a standard switchplate (toggle type like the WS467 does). Price is not an object at this point because I am looking at giving all back otherwise.
Any ideas?
Thanks.
RJ
Is there a Neutral Power Wire available in the spot where the problem is?
This may assist in a possible replacement as some do need a neutral wire. I also gather you want it to dim and not be just on or off.
Quote from: Brian H on October 16, 2006, 06:04:14 PM
Is there a Neutral Power Wire available in the spot where the problem is?
This may assist in a possible replacement as some do need a neutral wire. I also gather you want it to dim and not be just on or off.
There is a neutral in the box but the WS467 does not have a neutral lead. It functions only with incandescent lamps (resistive load). I don't need to dim. Just need it to stay off till it is turned on.
RJ
Reason I asked about a Neutral is some switches use it. That way the power is not being stolen through the load like the WS467 does. Will see if I can find anything on other brand switches.
Quote from: Brian H on October 17, 2006, 02:12:42 PM
Reason I asked about a Neutral is some switches use it. That way the power is not being stolen through the load like the WS467 does. Will see if I can find anything on other brand switches.
Thanks, I ordered a ToggleLinc at 3 times the price of the WS467. Hopefully it will fill in places where the WS467's won't work. I like the X10 switches and they work in over 90 percent of the places I have tried to use them. Also give me a reasonable profit margin so I don't have to do projects only for the rich.
RJ
Did you download the users manual. Just so you know how it works. I don't know if the switch uses dials like X10 or is programmed by X10 commands after putting it in a program mode. All of mine are signal programmed but I have a mix of Insteon and X10 right now.
Quote from: Brian H on October 17, 2006, 06:31:30 PM
Did you download the users manual. Just so you know how it works. I don't know if the switch uses dials like X10 or is programmed by X10 commands after putting it in a program mode. All of mine are signal programmed but I have a mix of Insteon and X10 right now.
Read the manual... says you put it in programming mode then send a command from some type of controller... like a remote.
RJ
In case anyone interested... the ToggleLinc switch cured this problem at this site. Don't know what it was but out of 15 WS467's I have installed this was the only location that had a problem. I will keep a ToggleLinc in my back pocket in the future but keep using the WS467's. Price is about 4 times as great.
RJ
Glad you got it to work.