X10 Community Forum
🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: marineau on December 26, 2006, 07:30:17 PM
-
I know that is possible with w800rf32a to get RF signal from DS10A !
But, I'm not sure... if I have 2 modules DS10A, first for a door, second for windows. Is it possible to know if signal Open or Close if it is for a first or second module ?
In others words, does a 4bytes that a ds10a sent are differents from others for same action ?
I ask you this because DS10A don't have a wheel for adjust HouseCode and UnitCode !
-
I know that is possible with w800rf32a to get RF signal from DS10A !
But, I'm not sure... if I have 2 modules DS10A, first for a door, second for windows. Is it possible to know if signal Open or Close if it is for a first or second module ?
As i know, you have to keep "TEST" button pushed while red led blink twice: it have just generated a new random code for that unit. At this point, opening and closing contacts, you're be able to see what X10 seq is for "open" and what for "close".
O-Zone
-
I know that is possible with w800rf32a to get RF signal from DS10A !
But, I'm not sure... if I have 2 modules DS10A, first for a door, second for windows. Is it possible to know if signal Open or Close if it is for a first or second module ?
In others words, does a 4bytes that a ds10a sent are differents from others for same action ?
I ask you this because DS10A don't have a wheel for adjust HouseCode and UnitCode !
The W800RF32A reports 4 bytes, of which 2 are significant. One is the random address mentioned by O-Zone, the other is the action code with bits for open/close,
min/max, and low battery.