X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: jason on March 13, 2007, 03:53:28 PM

Title: How can I activate the menu of "On During the day" in Timer Wizard?
Post by: jason on March 13, 2007, 03:53:28 PM

Hello,

How can I activate the menu of "On During the day" and "On at Night" in Timer Wizard?
I already setup it Location of "Hardware Configuration".
Is it the hardware problem of CM15A?

I attached the screenshot.
(http://www.turtlebackshop.com/data/hardware.jpg)

Thank you in advance.

Title: Re: How can I activate the menu of "On During the day" in Timer Wizard?
Post by: jason on March 13, 2007, 04:07:36 PM

Is it the same problem with Outer Marker?

Title: Re: How can I activate the menu of "On During the day" in Timer Wizard?
Post by: Dan Lawrence on March 13, 2007, 07:48:38 PM

Easy.

Set up the modules that will have timers.

You can set up at timer to turn on at sunrise and off at some later PM time.  You can have have as many timers on a module you want.

As an example, my outside lamppost and Motion Detector Spotlight are both controlled by timers (the lamppost is controlled by an X10 wall switch and the Motion Detector Spotlight is an X10 unit) the units have two timers each. One timer turns both on a 6:30 AM and off at 7:30AM weekdays and the second timer turns both on 25 minutes before dusk and off at 12:35 AM every day of the week.