X10 Community Forum
🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: JHGELLIOTT on July 30, 2007, 08:08:41 PM
-
I recently purchased a MS16A to interface with my existing activehome controlled house. Upon testing this product I was disappointed with the options relating to night and day. There should be a setting to detect motion at all times and only turn on the unit code +1 at night. This would allow a set of macros to act differently if the sensor is activated during the day or at night. Unless I am mistaken, there is no other way to differentiate night and day when activating a macro with a MS16A. ???
-
........... there is no other way to differentiate night and day when activating a macro with a MS16A. ???
"when activating a macro" ?..... are you using AHP (CM15A)?
The AHP calculates light/dark based on location and time (which can be used in a macro).
However I am not a big fan of clock-timers for lighting control (clouds can make a big difference). I use the hardwired floodlight (PR511) which has setting that can detect 24 hour montion AND light/dark settings (sending an X10 command).
-
I recently purchased a MS16A to interface with my existing activehome controlled house. Upon testing this product I was disappointed with the options relating to night and day. There should be a setting to detect motion at all times and only turn on the unit code +1 at night. This would allow a set of macros to act differently if the sensor is activated during the day or at night. Unless I am mistaken, there is no other way to differentiate night and day when activating a macro with a MS16A. ???
Based on the instructions here: X10 KNOWLEDGEBASE - MS16A ACTIVEEYE INSTRUCTIONS (http://www.x10.com/instructions/ms16a_inst.htm)
The MS16A defaults to detecting motion at all times and not sending the unit-code plus one dusk signal at all.
However, the instructions show that you can change that. See the section titled: Setting The Dawn/Dusk And Motion Detection Mode, which says that a setting of 3 blinks selects motion detection on at all times and unit-code plus one dusk signal turned on.
Hope that helps.
-
The problem with option 3 is that it does not turn on unit code +1 on/off when motion is detected. It turns unit code +1 on at dusk and then off at dawn. That is what the documentation says, I assume this is what it does. ???
-
The problem with option 3 is that it does not turn on unit code +1 on/off when motion is detected. It turns unit code +1 on at dusk and then off at dawn. That is what the documentation says, I assume this is what it does. ???
You are correct, it doesn't do that.
It enables motion detection at all times (signaled by unit code on/off) and enables the dusk /dawn feature (signaled by unit code +1 on at dusk and off at dawn).
Is this not what you're asking for? ???