🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: sherrodclan on January 31, 2008, 09:21:38 PM
Title: X10 Switches not working through AHP after Power Outage
Post by: sherrodclan on January 31, 2008, 09:21:38 PM
My X10 switches are not working through AHP after I had a power outage. Are the switches that sensitive? Does anyone have an idea of what might have happened or what I should do?
Title: Re: X10 Switches not working through AHP after Power Outage
Post by: -Bill- (of wgjohns.com) on January 31, 2008, 09:39:41 PM
My X10 switches are not working through AHP after I had a power outage. Are the switches that sensitive? Does anyone have an idea of what might have happened or what I should do?
My CM15A frequently refuses to function after a power outage until I clear it and re-download timers & macros.
Title: Re: X10 Switches not working through AHP after Power Outage
Post by: sherrodclan on February 02, 2008, 06:48:37 PM
How do you clear the CM15A module?
Title: Re: X10 Switches not working through AHP after Power Outage
Post by: Dan Lawrence on February 02, 2008, 11:45:59 PM
Open AHP. You can clear the CM15A through it. After you clear it, you can re-download all timers and macros.
Title: Re: X10 Switches not working through AHP after Power Outage
Post by: KDR on February 03, 2008, 10:48:15 AM
You can also unplug the CM15A, Remove the batteries and wait about 10 to 15 minutes. Then hook it back up and upload your AHP settings to it.
Title: Re: X10 Switches not working through AHP after Power Outage
Post by: grumps96 on February 20, 2008, 03:40:35 PM
;) I do not know if a power failures preceded my problem, but all my X10 units stopped working. it was this way for over a week. I have a receiver set to the frequency of X10 and was receiving a strong unmodulated signal on it. I spent days trying to locate the source. eventually I unplugged the AHP module and took out the Batteries, voila the signal stopped, and I was able to use my X10 controls again. I did have to reload my macros but that was to be expected.