X10 Community Forum
💬General Category => General Discussion => Topic started by: bitman on August 31, 2008, 06:38:13 PM
-
So the x10 lamp controller next to my spot on the couch quit turning on the lamp it was connected to.
After digging behind the couch to retrieve it so I could cycle power to it and re-address it while I was back there. It still did not work.
I went and got another remote from the basement. On my way downstairs I surmised that maybe my TM751 was hung but the remote in the basement turned on the devices there so up the stairs I went with the 2ond remote. I tried that. No go. So I went into the bedroom to see if I could control those lights. I could.
The bulb was bad. (http://www.gearslutz.com/board/images/smilies/sulkoff.gif)
-
You are not alone. I have done similar things myself. :'
-
Ooooooooo. That's a tad worse than troubleshooting a new macro for a couple of hours - only to find it doesn't work if you don't upload/save it.
Great Smiley!
-
............. worse than troubleshooting a new macro for a couple of hours - only to find it doesn't work if you don't upload/save it.
Been there!
-
bitman,
GREAT STORY! We all laughed because we have all done it.
Thanks for sharing.
Now I have to ask.
You said:
"After digging behind the couch to retrieve it so I could cycle power to it and re-address it while I was back there."
Are you talking X10 module? or is that "writers embelishment"? :D