X10 Community Forum

💬General Category => General Discussion => Topic started by: bitman on October 28, 2008, 04:14:44 PM

Title: Motion Sensors - retaining config.
Post by: bitman on October 28, 2008, 04:14:44 PM

I have three motion sensors. 2 ms12a set to transmit A9 and wait 4 minutes before sending an x10 off.
One ms16a sends A8 and has dusk/dawn off and waits the default 1 minute before sending an x10 off.

When I change the batteries, They go back to their defaults.

Is there a way around this issue like changing one battery at a time ?

Title: Re: Motion Sensors - retaining config.
Post by: Brian H on October 28, 2008, 04:18:30 PM

No.
That is how they act. Default A1. Dusk Dawn on A2.

Title: Re: Motion Sensors - retaining config.
Post by: bitman on October 28, 2008, 04:22:03 PM

SugerBuger!  :'(