X10 Community Forum

💬General Category => General Discussion => Topic started by: bitman on November 28, 2008, 05:46:16 PM

Title: How does one tell a CM15A not to tranceive on a particular house code?
Post by: bitman on November 28, 2008, 05:46:16 PM

Sorry, this has been probably asked before but I cannot find the exact answer.

How does one tell a CM15A not to transceive on a particular house code. Is it done within ActiveHome Pro?
This is an advance question as I have not upgraded to PRO yet and with to use my tm751 to control the house code it does now after upgrade. Letting AH PRO control all others. (That are way closer to the weak CM15a by the way) .  ;)

Thanks.
:Ron

Title: Re: How does one tell a CM15A not to tranceive on a particular house code?
Post by: Jsnlong on November 28, 2008, 05:55:12 PM

You do it Active home Pro Under the Tool menu. and select Hardware Configuration. Then in the lower right hand corner you Will see the box marked Transceiver House codes. Just check mark the ones you want the CM15a to Transceiver. Then Press Update Interface.

Title: Re: How does one tell a CM15A not to tranceive on a particular house code?
Post by: bitman on November 28, 2008, 06:31:04 PM

Ta-Da! Thanks.
This is what I wanted to hear.

 :)%