X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: kepinel on February 17, 2009, 07:07:16 PM

Title: How do I control a TM751 Mini Transceiver with Active Home v1.4?
Post by: kepinel on February 17, 2009, 07:07:16 PM

Please disregard, solution found.

How do I control a TM751 Mini Transceiver with Active Home v1.4?

I cannot seem to control the switch portion of my TM751 Mini Transceiver via CM11A and ActiveHome v1.4. 

I am thinking it is a problem with Module Selection in the Active Home software.  As there is no TM751 Module available, I have tried using the RR501 as well as both of the two pin appliance modules available.  Using the "All Lights On/Off" commands does not help.

The TM751 House Code is set on A, there is no selectable Unit Code (defaults to 1, I believe).

My EagleEye is set to trip a Lamp Module LM465 via the TM751 and that works fine.

Mini Transceiver TM751 set A
EagleEye MS14A set A1
Lamp Module LM465 set A1
Computer Interface CM11A

Thank you in advance for your help...

Title: Re: How do I control a TM751 Mini Transceiver with Active Home v1.4?
Post by: steven r on February 17, 2009, 08:42:07 PM

Why not share your solution? There could be at least one other person out there still using AH v1.4.  :)

Welcome to the forum! Feel free to post any other questions that may come up for you. It's been a while since many of us have worked with AH v1.4 but there is a wealth of resources here for information.

Title: Re: How do I control a TM751 Mini Transceiver with Active Home v1.4?
Post by: dave w on February 17, 2009, 10:30:53 PM

krepenil probably meant "Answer found" because I don't think a CM11 (Active Home 1.4) can control a TM751. The CM11 can not send RF.

Title: Re: How do I control a TM751 Mini Transceiver with Active Home v1.4?
Post by: Brian H on February 18, 2009, 06:38:45 AM

Right and the TM751 has no power line receiver in it. Thus can't be controlled by any power line signals.