X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: garagedude on April 30, 2009, 10:04:14 PM

Title: Video Commander question
Post by: garagedude on April 30, 2009, 10:04:14 PM

I have a UX23A video commander II which works fine if I use a remote to trigger the unit to record, but it will not start recording from anything else. Else being the PR511 or any macro. The CM15A is only 10 ft from the UX23A and the computer with the macro. The macro has an RF command it but doesn't work. It will turn on the cams, including the PR511 so I'm at a loss? what does the trigger do on the macros? I've tryed differant unit codes with no luck?

Title: Re: Video Commander question
Post by: Tuicemen on May 01, 2009, 07:33:51 AM

The trigger in the macro is what AHP watches for and starts the macro when it receives that code.
 ;)

Title: Re: Video Commander question
Post by: garagedude on May 01, 2009, 07:48:05 PM

O,, Ok, that makes since. So if I got it figured out, the motion sensor will trigger the macro, which will trigger the cam which will start the sweep, but I haven't yet got the commandor II working with all this. Should the commandor be set to the same code that triggers the macro? I've tryed RF commands but the commandor ignores them??