X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: birdzeye on July 30, 2009, 05:05:14 PM

Title: different housecodes, same unit code triggered on both
Post by: birdzeye on July 30, 2009, 05:05:14 PM

One camera on B11 and a light on E11 are both turning on when only the B11 camera is triggered ON by RF remote. Why is this happening?

Title: Re: different housecodes, same unit code triggered on both
Post by: steven r on July 30, 2009, 06:02:11 PM

I've never heard of a duel RF signal coming from a remote.
Barring a macro to tell it to turn on the other, it appears that the devices functionally consider themselves on the same address.
There's a chance that the dial setting is wrong or even a small chance that the setting dial is defective. Go to to the device that shouldn't be coming on and reset it's code. If it has dials, rotate them a few times before resetting.

Title: Re: different housecodes, same unit code triggered on both
Post by: robotmaker on July 31, 2009, 08:01:55 PM

also try different house codes on remote or try using another rf sending device to see if its a bad remote