X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: joako on December 04, 2009, 02:45:25 PM

Title: Homelink Programming
Post by: joako on December 04, 2009, 02:45:25 PM

I want to program RF commands to a HomeLink garage door opener. According to my owners manual for this sort of programming I should consult my dealer, however I doubt they will know what I am trying to do.

How would I go about programming the buttons?

Title: Re: Homelink Programming
Post by: Mellowmark on December 04, 2009, 03:40:23 PM

there is some other post on this and I haven't done it YET.   If it is a learning remote you are supposed to be able to follow the same directions you would for your garage door, only substitute an x10 remote set to the right code you wish to use.

good luck