X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: mykidsbutler on April 20, 2010, 10:59:43 PM

Title: Older WS467 will not turn on/off at switch
Post by: mykidsbutler on April 20, 2010, 10:59:43 PM

Have older type WS467 that operates two outdoor lights. The problem is the switch has stop working at the switch(lights stay on). I push the button and i get no response. Does not operate when commanded by the motion sensor or the CR12A remote. Sliding the switch below the button will cut the lights off but when switched back on the lights come back on. Tried a new switch and still the same problem. B:( I have a 16oz ball peen hammer I'm going to adjust it with :' but i thought i would try this forum first. Would appreciate any idea!!

Title: Re: Older WS467 will not turn on/off at switch
Post by: Brandt on April 20, 2010, 11:47:05 PM

what happens when you follow the directions in the manual for dimming such?

Title: Re: Older WS467 will not turn on/off at switch
Post by: Brian H on April 21, 2010, 06:40:19 AM

If both switches tried are going back on as soon as power is applied or the cut off switch is activated. You may want to check for a stuck button on a controller or remote sending a stream of on commands to the switches X10 address.
Are you using a CM15A controller and a X10 signal repeater? If so what brand and model repeater?