X10 Community Forum

🖥️ActiveHome Pro => Plug-ins => iWatchOut/iWitness => Topic started by: Aaron1312042 on April 25, 2010, 03:53:15 PM

Title: What is needed to add cams for AHP
Post by: Aaron1312042 on April 25, 2010, 03:53:15 PM

I know I need iWatch for AHP but am confused as to what hardware is needed for a multi-cam setup.

Here is what I think I need:

VR36A
VA11A

Am I correct? Thanks

Title: Re: What is needed to add cams for AHP
Post by: Brian H on April 25, 2010, 06:50:00 PM

The VR36 will receive the video from the cameras.
The VA12A [VA11A supreceeded by VA12A] will take the video from the receiver and input it into the computer.

You will still need a way to switch the cameras on and off as only one can be on at a time. By sending an X10 on and off power line signal to the cameras power supplies.
I believe the  UR19A interface that send RF to a TM751 to control the supplies are used.

There are some install instructions here:
http://www.x10.com/instructions/
http://kbase.x10.com/wiki/IWatchOut

Title: Re: What is needed to add cams for AHP
Post by: Aaron1312042 on April 25, 2010, 08:15:31 PM

Or Mortion Detectors for switching. Thanks very much for the info.  ;D