X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: gator.bigfoot on November 06, 2010, 05:01:58 PM

Title: module needs power cycle every few days
Post by: gator.bigfoot on November 06, 2010, 05:01:58 PM

I have an eagle eye motion sensor running a macro.  The macro turns on lights (XPS3).  This works for a few days and then stops working.  I do a power cycle on the module and voila everything works again for the next few days.  Any ideas??

Thanks,
Walter

Title: Re: module needs power cycle every few days
Post by: Brandt on November 06, 2010, 06:27:45 PM

Which module?

Title: Re: module needs power cycle every few days
Post by: Brian H on November 06, 2010, 06:44:39 PM

Brandt, XPS3 is a relay type wall switch by X10Pro.

Can you control the XPS3 with direct commands from the CM15s screen when it is unresponsive?

Title: Re: module needs power cycle every few days
Post by: Brandt on November 06, 2010, 06:55:53 PM

Well he mentioned scripts so he may gave been referring to an AHP controller module.

Title: Re: module needs power cycle every few days
Post by: Brian H on November 06, 2010, 06:56:47 PM

Could be. Clarification from OP will help.

Title: Re: module needs power cycle every few days
Post by: gator.bigfoot on November 06, 2010, 07:29:14 PM

Yes the XPS3 needs the power cycle.
I cannot control the module from AHP until I cycle the power. Then it works for a few days and then it happens again. It does turn on and off from its own control just not from AHP.