X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: tom j on January 20, 2011, 12:54:16 AM

Title: New Hardware Found??
Post by: tom j on January 20, 2011, 12:54:16 AM

Hi just installed AHP after upgrading my hard drive and when I plug in the usb cable I get the following message. New Hardware Found, It then asks for the software I guess to get the drivers?? I don't remember this happening when I first installed the software. There's no disk with this software so what should I do currently running XP. Thanks

Tom j.

Title: Re: New Hardware Found??
Post by: Brian H on January 20, 2011, 06:13:10 AM

When AHP is installed it should also have installed the drivers.
I know evertime I updated AHP the first time I reconnected the CM15A or CM19A it said new hardware found and then found and used the drivers.
This is from the wiki.
http://kbase.x10.com/wiki/ActiveHome_Pro_Installation_Asks_for_Disk

Title: Re: New Hardware Found??
Post by: tom j on January 26, 2011, 09:03:06 AM

Quote from: Brian H on January 20, 2011, 06:13:10 AM

When AHP is installed it should also have installed the drivers.
I know evertime I updated AHP the first time I reconnected the CM15A or CM19A it said new hardware found and then found and used the drivers.
This is from the wiki.
http://kbase.x10.com/wiki/ActiveHome_Pro_Installation_Asks_for_Disk

Well I told it to look for the drivers and I guess it found them, just don't remember that happening before of course it's been a while since I've done an install. Thanks for the link.

Tom j.