X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: mattwarner on May 01, 2011, 03:12:54 PM

Title: WS13A installation questions
Post by: mattwarner on May 01, 2011, 03:12:54 PM

I am installing two WS13A switches side-by-side in a single gangbox.  Can I install them by running a "jumper" cable from the unused port for each of the line and neutral from one to the next, rather than running a separate line to each?  the box is already pretty tight, so I'd rather not add separate wires for each if I can conserve space.

Also, there are neutral (white) wires from both loads coming into the box and out to a neutral line, but they're just connected together now and not connected to the current switch.  Do I just run a new wire from the X10 switch into that same bundle?

Thanks for any help!

Title: Re: WS13A installation questions
Post by: dave w on May 01, 2011, 05:05:22 PM

Yes
Yes

Title: Re: WS13A installation questions
Post by: mattwarner on May 01, 2011, 07:12:28 PM

Thank you!