X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: southtoms on May 01, 2011, 11:47:58 PM

Title: MS12a a/c mod
Post by: southtoms on May 01, 2011, 11:47:58 PM

I'm trying to do the a/c mod. The directions say put the 10k on the left side, but the diagram shows it on the right side. Anyone know?

Title: Re: MS12a a/c mod
Post by: Brian H on May 02, 2011, 06:38:48 AM

Physical board layouts and schematics can't be directly compared.
You will probably find the left side of the jumper wire is connected to the R10 and U1 pin 5 connection shown on the right side of the cut jumper in the schematic.

I would connect the 10K resistor where it is shown in the photo. Left physical side of the cut jumper.