X10 Community Forum

🔌General Home Automation => Automating Your House => Topic started by: blulaserstar on September 22, 2011, 04:34:11 PM

Title: Can I use x10 with this system?
Post by: blulaserstar on September 22, 2011, 04:34:11 PM

hi i'm matteo, i write from italy (sorry for my english), but i have a
doubt that i hope only you can solve!
i want to use a touch command for light and i would like to put the light on whe i enter in the room e i would like to put the light off from the command on the beh for example.
So the producer give me this two products, the touch command http://www.ave.it/catalogo/manuali/C0572_rev02.pdf (http://www.ave.it/catalogo/manuali/C0572_rev02.pdf) and the "normal command"! http://www.ave.it/catalogo/scheda.asp?lingua=IT&professionisti=&id=6560&idcat=738 (http://www.ave.it/catalogo/scheda.asp?lingua=IT&professionisti=&id=6560&idcat=738)

(I do so becouse use all touch command is too expensive, so i use the touch command in the corridor and a simple command in the room!!)

This two command can be interfaced with the x10?
my reseller of x10 says that the relè of touch command could be command by x10 module! is true?

Title: Re: Can I use x10 with this system?
Post by: luke03 on September 30, 2011, 01:37:45 PM

If this device already controls the electricity, what do you want to use X10 for?

Title: Re: Can I use x10 with this system?
Post by: Brian H on September 30, 2011, 03:11:17 PM

The way I read it. To use an X10 device to trigger it instead of having all of the controls touchscreen that are expensive.