X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: vpmedia on February 26, 2012, 06:52:47 PM
-
I see one cam witch is about 50 feet away and when I hook up the 2nd cam I still see the first cam, I cant see both at the same time. I move the receiver a little bit and then I see the 2nd cam on both screens...?????? Any Clue is to what is happening...???
Please help...
-
If these are X10 cameras and not the "Airxxx" cameras, you can only have one camera on at a time. You only have one receiver which can only receive one camera at a time. If this isn't your situation you need to provide a more details. We are not good at guessing what "@ cams" are.
-
Very sorry.. 2 cams 1 xx20a b/w and 1 18a color cam, I was wanting to see the front of the house and the back at the same time and have it switch every 15sec. but I can only see 1 at a time in both cam frams in I-watch, Both are labled C2 and C4, 1 cam is 50ft and the other is 15ft. If I move the receiver a little bit I will see the deck cam in both frames move it back and I see the front of the house. Why cant I see both cams in there own frame. any thoughts
-
What software are you using to switch and display the cameras?
What X10 interface are you using the software on?
Only one camera can be on at a time.
They work in groups of four. Same House Code {C in your case} and Units 1-4,5-8,9-12 and 13-16. You are in the same 1-4 Unit Group.
Turning any one in a group turns the other three off. They are controlled by a power line command.
One of the cameras is on C2 and the other on C4 correct?
-
Yes C2 and C4 and I am using AHP and I-watchout