X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: downsouth on April 17, 2012, 10:06:01 PM

Title: WS13a's failed after one try
Post by: downsouth on April 17, 2012, 10:06:01 PM

Installed 2 ws13a's on the same circuit to be controlled by an sc1200. Installation went fine. Dialed in and tried the lights, came on and turned off. Tried to demonstrate the system to the wife 4 hours later - could not control the ws13a's. Tried doing so with a Mini Controller no luck. I do have a lamp module on the same circuit that worked fine before the ws13a's were installed and still does.

Whut up?

Thanks

Down South

 B:(

Title: Re: WS13a's failed after one try
Post by: kenrad on April 17, 2012, 11:16:40 PM

Do the lights switch locally?

Title: Re: WS13a's failed after one try
Post by: Brian H on April 18, 2012, 06:04:53 AM

If they don't work locally as suggested.
Double check your wiring.
Verify you have a real neutral power wire.

If they work locally. You may have power line signal issues.