X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: MrReaL on May 20, 2012, 05:51:07 AM

Title: Create marco with housecode?
Post by: MrReaL on May 20, 2012, 05:51:07 AM

Hello,

Is it possible to trigger a Macro by a house code? My CM15Pro receives the code A (no number) and this triggers a Marco that turns 1 or more lights on?

If so, how do i set this up within ActiveHome?

Greets,

Erwin

Title: Re: Create marco with housecode?
Post by: gg4000 on May 20, 2012, 06:54:18 AM

Try setting the Macro to A1

Title: Re: Create marco with housecode?
Post by: MrReaL on May 20, 2012, 06:59:45 AM

Do you think this wil have the same effect? I'm trying to use my Logitech Harmony 1100. The Harmony can only send a house code or a number, for some stupid reason logitech removed the macrofunction from the new remotes. With my old Harmony, the 1000, i was able to set a little marco in the remote sending House code, number and command.

Title: Re: Create marco with housecode?
Post by: gg4000 on May 20, 2012, 08:24:48 AM

I just tried this. Added a new transceiver module A. When I click it A1 macro got triggered. Not A2 or any others.

Title: Re: Create marco with housecode?
Post by: MrReaL on May 21, 2012, 01:54:34 PM

Okay, tested it, no success. I use:
- Harmony 1100 (a button configured sending housecode A)
- IR724: Receiving signal passing it through on to the electrical network
- CM15: a Marco set on receiving "A1 On" as said this would be the effect if only "A" was send. This Marco turns on a light on a different house code (P1 On)

It seems my configuration does not send the signal A when pressing the button (Using the activity monitor within ActiveHome). However, when pressing the button with housecode A followed by the signal "On" the activity monitor registers the commando. This is still 1 button more then what i would like to achieve.

Any ideas?