X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: pantasos on June 25, 2012, 01:47:35 PM

Title: Help for MS13E and Active home
Post by: pantasos on June 25, 2012, 01:47:35 PM

I would like your help to create a macro with the following characteristics:

I have two in my line AW12 Addressed A4 and A5
and a sensor MS13E for not knowing what direction to give and what to give the corresponding length to operate. I want to give the A4 command ON after 2 minutes ON and OFF the A5 and two after 5 minutes. It's simple I know. I have done all the combinations and the Active Home receives the signal from MS13E nonetheless MACROS not activate commands. For example when I put in a common direction with a MS13E AW12 then it responds. I do not know if there is a conflict with the commands stored in MS13E. I need a plan to understand the process.

thank you
Sorry for my bad English

[IMG=http://img580.imageshack.us/img580/152/assign2.jpg][/IMG] (http://imageshack.us/photo/my-images/580/assign2.jpg/)

Uploaded with ImageShack.us (http://imageshack.us)

Title: Re: Help for MS13E and Active home
Post by: Brian H on June 25, 2012, 03:34:49 PM

Is the MS13E is set to the default A1?
Your macro is showing modules on A1 and A2 not A4 and A5. You are trying to use A4 and A5 in the AW12s?

Title: Re: Help for MS13E and Active home
Post by: pantasos on June 26, 2012, 07:53:24 AM

Quote from: Brian H on June 25, 2012, 03:34:49 PM

Is the MS13E is set to the default A1?
Your macro is showing modules on A1 and A2 not A4 and A5. You are trying to use A4 and A5 in the AW12s?

right photo used is indicative of the MS13E have done A2 and A3 traffic day and night for the macros that can give direction;