X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: leonpc on February 21, 2013, 03:06:51 AM

Title: CM15A and CM19A
Post by: leonpc on February 21, 2013, 03:06:51 AM

Based on my question in a previous post ( http://forums.x10.com/index.php?topic=28044.0 (http://forums.x10.com/index.php?topic=28044.0) ) I was wondering if there are issues having both a CM15A and a CM19A installed on a single system interacting with AHP?

I suspect that you will see duplicate commands received from RF like 2 "D8 ON" being issued but will it really hurt anything.

TIA

Leon

Title: Re: CM15A and CM19A
Post by: Brian H on February 21, 2013, 06:08:33 AM

The later versions of AHP both the CM19A {part of the CM15K kit] and CM15A where supported. Would probably crash as it was not designed to use both the CM19A and CM15A at the sametime.

Title: Re: CM15A and CM19A
Post by: kenrad on February 21, 2013, 06:47:52 PM

In my setup I run both of them, but I only use the SDK with ihouse as the software.  I don't however run them on the same PC,  if they are with in range of each other you will see duplicated commands, the only issue that I seen for this is if you have a program that uses VR or TTS (a talking house) because then the Pc will repeat the command twice but other than that it doesn't affect the x10 function.

 >!  Ken

Title: Re: CM15A and CM19A
Post by: leonpc on March 11, 2013, 03:31:09 PM

Thanks for the reply.  I have installed both the CM15A and the CM19A on the same system and so far they seem to be working together.  I have to admit that I am wondering why I would use the CM19A if the CM15A is within 4 feet of it....

The CM19A was one of the modules that was sent to me when I ordered the MyGarage setup.  I am using a transceiver in the garage to pick up the signal and should not need the CM19A.