X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: soniacastle on May 13, 2013, 02:34:57 PM

Title: Help with a PHR03/PAT01
Post by: soniacastle on May 13, 2013, 02:34:57 PM

I apologize in advance for posting in this area, but I couldn't figure out where to ask this question and I've sat on hold with X10 for almost an hour now.

I have these two devices, inherited from previous owner of home. I also have pool lights that turn on without my turning them on; I assume because of competing signals from neighbors. How can I reprogram what I have to stop this?

Thanks for any and all help!

Title: Re: Help with a PHR03/PAT01
Post by: Brian H on May 13, 2013, 03:54:56 PM

Manuals for the two modules you mentioned.
http://www.x10pro.com/pro/pdf/pat01.pdf
http://www.x10pro.com/pro/pdf/phr03.pdf

If the pool lights are not on the pat01's switched outlet. You have one more module connected to the pool lights.

I would also give the home a real good looking at for an X10 or X10Pro controller or timer. As getting an X10 signal from a neighbors home is possible just not very probable.

You can try a different House Code Dial setting. Making sure all the modules are set to the same House Code. If you find an X10 Timer or computer controller. They will also need to have their X10 address changed to match everything else.