X10 Community Forum
🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: Marauder2003 on December 24, 2013, 09:43:40 PM
-
Please see http://myimagecollection.com/ftp/layout.pdf for a diagram
A is the main panel on the outside of the house facing south. 110F plus in the summer.
B is a secondary panel on the inside of a south facing wall. Still gets warm. I have an exhaust fan that triggers at 120F. It does run at times. :)
C is a 3rd panel on the inside of the house.
For product life expectation I would prefer to use panel C for the XPCR. Would it still serve a purpose there?
The diagram says the unit should be connected to CBs. Any reason it can't be connected to the CB on a seldom used circuit?
-
Installed in panel C. Light blinks when event occurs. All seems fine.