X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: bkenobi on January 16, 2015, 11:38:20 PM

Title: AHP CM15A driver
Post by: bkenobi on January 16, 2015, 11:38:20 PM

I am using a different software for my HA system these days.  That being said, I have AHP installed on my file server and would like to run a test on it.  When I plugged the CM15A into it, the driver was set to a different one than AHP needs.  As a result, when I try to run AHP I get an error:

Code: [Select]

Error Getting X10Net Interface
I'm sure this is related to using the wrong USB driver.  Can someone point me to the correct location of the inf file that I need to use to switch over drivers?  I know it's on the system since I've switched back before, but I can't seem to remember where it was located.

Title: Re: AHP CM15A driver
Post by: bkenobi on January 17, 2015, 01:12:45 AM

Never mind.  I forgot that I stopped the X10 service to allow the other driver to install.  After setting it back to "Automatic" and starting the service, AHP starts like a champ.  That's 3 hours I won't get back.   B:(

Title: Re: AHP CM15A driver
Post by: Tuicemen on January 17, 2015, 09:06:00 AM

 rofl Been there!.............. ::) :'
Several times. :-[

Title: Re: AHP CM15A driver
Post by: joe s. on January 17, 2015, 10:03:34 AM

Try to be philosophical - would you have cured the common cold in that same timeframe -:)?