Hello
I plan to install 9 or 10 different 110v landscape lights to illuminate my very tall palm trees (thus the need for 110v; 12v lights won't reach high enough).
I plan to supply them with one 12/2 cable run, and I'll use an xps4 switch to control them all; i will probably use led bulbs, but I may use cfls.
Does this sound ok? Should I use an xpfm module instead?
The XPS4 will work with both inductive and resistive loads according to the documentation. It is supposed to be a new version of the XPS3 which I use in a few locations (both for lights and for fans). This configuration should work fine for what you are looking at as long as you don't exceed the max load. All I see is that it has a 20A relay, so that probably means the max load is 20A, but it would be good to verify that.