X10 Community Forum
📱X10 WIFI => 🗯General Discussion => Topic started by: frmichaud on December 07, 2022, 12:28:52 PM
-
I receive a WM100 and my house has a VHF and UHF network
I connected the WM100 on an AC plug and when I go to set up I discovered that the WM100 is trying to connect on my UHF net work and noway to forced him to connect to VHF network
Can some body told hoe to forced the WM100bto disconnect to UHF and connect to VHF
Thanks for your help
Francois
-
The WM100 is a 2.4 GH WI-Fi module.
Can you tell us what you mean by VHF and UHF networks.
As the description VHF and UHF don't describe the network you should be using.
-
This may give you more information.
https://www.x10.com/pages/wm100-FAQ
-
I know that the WM100 is a 2,4GHz what I called by error Vhf When I reseive my WM100It immedatly connect tmy 5GHZ network
-
Thank you for the clarification.
You are not alone with routers picking the 5.0 GHz band.
There are other posts here on some fixes found by others.
One thread on this is: https://forums.x10.com/index.php?topic=31632.0
Until others may post their findings to you.
-
I know that the WM100 is a 2,4GHz what I called by error Vhf When I reseive my WM100It immedatly connect tmy 5GHZ network
Make sure your phone is connected to 2.4 and not 5G before starting. It's best to set up your router with different SSID's for 2.4 and 5G radios. If you need help with that tell us what brand & model router you have.
-
I just tried what someone posted. I went into my mode's wifi, advanced setting area. I was allowed to deactivate the 5g Setting; Ihit save button. I then reconnected my wm100; It worked. I also connected my 2.4 cameras. They work. I went back and activated the 5g (in my modem) setting and saved it. Everything works