X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: dshoe on December 05, 2005, 02:23:33 PM

Title: Timers and Macros don't work, cm15
Post by: dshoe on December 05, 2005, 02:23:33 PM
Have used a cm 11 for years. upgraded to
AHP and CM15 in Oct 2005.
Tried to do everything a step at a time.
1st. using cm15 as a transciever, hand held
controller, 1 house code, 2lamp modules.
Worked OK.

2nd. 1 house code, one lamp module, Dusk to
Dawn (on at night). Saved, ran from
computer, OK.

3rd, same as 2nd, but downloaded to cm15.
Time off by 3 hours, checked interface
clock, and location, both corect.
next day, didn't come on at all.

4th. Tried a  macro, 1 house code, one lamp
module, run from computer, ok. Downloaded
to cm15, and didn't work.

5th. Tried a RMS18 detector, one lamp
module, same house and unit code. OK.

6th. Tried a macro, one detector, 2 lamp
modules, detector on c1, lamps on c3 and
c5. Ran from computer, ok. downloaded to
interface, doesn't work.

7th. tried different combos on house codes,
etc. (auto, manual) (cleared interface,
reset everything) same results.
Timers/macros will run from computer, but
not from interface.

Have run out of ideas to try . Any
suggestions ?

Thanks


Title: Re: Timers and Macros don't work, cm15
Post by: arf1410 on December 05, 2005, 06:39:08 PM
unit is under warranty - save the
frustration and exchange it.  Scan this
forum, and I don't think you will find a
single incidence of a CM15A recovering from
the problems you mention.
Title: Re: Timers and Macros don't work, cm15
Post by: dshoe on February 13, 2006, 12:33:00 PM
Thanks, Called and had my CM15 replaced.
Timers and Macros work. Still have other
normal problems but workable.