X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: paul on January 07, 2006, 10:25:14 PM

Title: remote controls don1t work
Post by: paul on January 07, 2006, 10:25:14 PM

my remotes toggle the on screen switches
but no light or lamps come on , when i use
the mouse to toggle switches it works
fine ......HELP ......

Title: Re: remote controls don1t work
Post by: poursha on January 07, 2006, 11:24:58 PM

Are you using the CM15A for RF only?  Do
you have another transceiver as well?  If
so, then try without the other transceiver
to see if that helps.

Also, maybe try rebooting your CM15A.
Unplug, and remove the batteries for a few
minutes.  Then plug it back in, and reload
timers/macros.

RoB

Title: Re: remote controls don1t work
Post by: poursha on January 07, 2006, 11:41:30 PM

Opps!  Sorry, forgot this obvious one that
gets everybody.  Check out this thread...

http://www.x10.com/news/msgb/index.cgi?
board=ahp-
uses&action=read&postid=000019&topid=625&num
of=

Title: Re: remote controls don1t work
Post by: dave on January 08, 2006, 06:55:29 AM

I just bought this X10 junk. Once again I
should not waste my Time and Money with
X10. I too have the same problem. I will
work but only if I plug in my TM751. The
new "PRO " CM15A is not Xmit on to the
power line. PRO JUNK

Title: Re: remote controls don1t work
Post by: Brian H on January 08, 2006, 07:15:46 AM

Dave; Did you enable the house code to be
tranceived? The software defaults to NONE!
That means you see the toggle on the screen
but no action on the modules.
Tools
Hardware Configuration
Tranceived House Codes
Enable the House Codes you are using.

Title: Re: remote controls don1t work
Post by: dave on January 08, 2006, 01:19:06 PM

Thanks