X10 Community Forum

🖥️ActiveHome Pro => Plug-ins => iWatchOut/iWitness => Topic started by: greg murrelll on May 12, 2005, 01:56:02 PM

Title: IWitness-Multiple Camera Question
Post by: greg murrelll on May 12, 2005, 01:56:02 PM

So, I have 4 cameras set to D1,D2,D3,D4.  I
have a TM751 set to D.  I set up the 4
cameras in Active Home, but it doesn't
matter what camera I select, I always get
the feed from D1.  What am I missing here?

Title: Re: IWitness-Multiple Camera Question
Post by: donald mcmow on May 13, 2005, 10:25:02 AM

Is there a particular reason for the TM751
in the setup? If the reason is not wiring
phase related then remove it from the
picture. If it is then you will have to
recode all of your camera activations into
macros using the RF command instead of the
camera switching commands. This is due to
the fact that the powerline commands are
being sent on the powerline and not over
RF. The TM751 is used to receive RF signals.

Title: Re: IWitness-Multiple Camera Question
Post by: Tuicemen on May 19, 2005, 10:04:53 AM

Donald McMow
You don't need to send you cam macros rf or
any thing else if you have the tm751
configured right in AHP. I Have a tm751 in
my configuration and no problems.
Greg Murrell you have to take the cam off d1
since it is the tm751 and everything should
work. My setup is on B, b4 is a cam anywhere
b5 is a wideangle and b1 is the tm751. (only
have 2 cams)

Title: Re: IWitness-Multiple Camera Question
Post by: dale kuker on June 10, 2005, 03:44:57 PM

I have four camers set to B1,B2,B3,B4 and  I
always get the feed from B2 and the 4 panes
show image from B2.