X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: emilio harris on November 02, 2005, 08:15:20 AM

Title: RF100
Post by: emilio harris on November 02, 2005, 08:15:20 AM

When connected to the load the RF100 is not
working properly.  It change from on to off
but the light do not change the condition.
I measured the voltage at the output and
shows in some cases 28 Volts.  I have two
of them and both have the same problem.

Title: Re: RF100
Post by: dave w on November 02, 2005, 12:04:13 PM

RF100?

Title: Re: RF100
Post by: roger1818 on November 02, 2005, 12:55:51 PM

By RF100 are you meaning the ACT Single Pole
- 20A, 120 VAC Feed Thru Relay?  If so, do
you have the black wire connected to the Hot
wire from the panel, the white wire connected
to the common neutral wire and the blue wire
connected to the load?  This module is no
longer in production, but he instructions for
this module can be found on ACT's website:

http://www.act-solutions.com/pdfs/PCCInst/rf100.pdf