X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: keith on February 09, 2006, 09:48:57 PM
-
I am findinG ahp quite buggy. It doesn't
seem possible to clear the interface. After
Issuing the command, interface still shows
all timers macros and prefences loaded. even
after unplugging and removing batteries!
Macros run unreliably and I notice that
spurious commands are being sent and I assume
it is the USB interface that is doing it--but
I cannot figure out how to stop it. Also old
ah1.42 (which kind of sucked) seemed to run
more reliably and issue commands thru serial
interface more powerfully than this one....
-
The statistics show you the what would be
used by your currently loaded AHP
configuration, not what is in the interface
memory. That's what the original ActiveHome
did, too. Clear Interface Memory is working fine.
In what way are macros running unreliably?