X10 Community Forum

🛡Home Security => Home Security General => Topic started by: Tom G. on September 04, 2004, 11:25:23 PM

Title: Will Power Horn work with a EagleEye Motion Sensor?
Post by: Tom G. on September 04, 2004, 11:25:23 PM

Will an EagleEye motion detector trigger a
power horn? If the motion detector and power
horn are set to the same code, would the
alarm sound off when triggered?

Title: Re: Will Power Horn work with a EagleEye Motion Sensor?
Post by: Brian H on November 03, 2004, 07:29:03 PM

I don't think so. The PH508 and SH10A need a
series of ON OFF commands sent to the
modules address to trigger them. The small
Chime Module SC546 can be triggered by a
single ON command to the address it is set
to.

Title: Re: Will Power Horn work with a EagleEye Motion Sensor?
Post by: Kenneth Herring on November 03, 2004, 08:59:46 PM

If the Power Horn needs an on-off signal in
order to work without an alarm console, then
a PowerFlash Interface Module (PSC01) might
do the trick. There is another post asking
about activating multiple lights on a
different house code in this same forum
where I list a Rube Goldberg method of
making this work. Look at it and see if it
helps you.