X10 Community Forum

🛡Home Security => Home Security General => Topic started by: don harper on September 04, 2005, 10:29:53 PM

Title: rocket-socket activation
Post by: don harper on September 04, 2005, 10:29:53 PM

i just received two new rocket-socket lamp
controllers.  i have followed the directions
attempting to activate them with no luck.
any suggestions?  thanks....dh

Title: Re: rocket-socket activation
Post by: Brian H on September 05, 2005, 06:27:03 AM

Use a temporary lamp that is on the same
circuit as the controller or tranceiver you
are using to program it. You have 30 seconds
after the power is applied to the module to
program it. So turn ON the power and send an
ON to the address you want it on three
times. Like if you wanted P16. Turn on the
AC to the module and send P10 ON three times.
Verify it works and move it to the place you
want it. What controller or tranceiver are
you using?

Title: Re: rocket-socket activation
Post by: Brian H on September 05, 2005, 06:27:57 AM

OH fumble fingers. If you wanted P16 you
would send P16 ON three times!