X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: J Lawson on March 21, 2006, 07:15:28 PM

Title: multi cameras in AHP
Post by: J Lawson on March 21, 2006, 07:15:28 PM

I have a 3 camera setup in AHP,when I switch cameras c1 c2 c3,most of the time c2 shows no video,the other 2 work fine.If I unplug the camera c2 and plug it in again it shows video fine,has anyone got a solution to this.
Thanks for any feedback.

Title: Re: multi cameras in AHP
Post by: X10 Pro on March 21, 2006, 07:30:03 PM

C2 probably isn't getting the command to turn on. Unplugging it and plugging it on makes it come on. Try moving the power supply to a different outlet. You could also swap places between C1 and C2 temporarily to see if it's the location or the camera itself.

Title: Re: multi cameras in AHP
Post by: J Lawson on March 22, 2006, 07:41:02 PM

I have one motion active eye and 3 camera setup in AHP,can you give me specific intructions to make my active eye work at my front door.I have a RF smart repeater and a transceiver and none seem to increase my RF range.I have tried both and I get no activity in the activity monitor,I also have a remote that I use at the front door and also get no response.X10 please solve this problem for me,or someone,anyone...
JL ::)

Title: Re: multi cameras in AHP
Post by: Mystyx on March 22, 2006, 09:41:02 PM

First have a look at this thread about not seeing one camera out of 3.
Multiple camera reception help! (http://www.x10community.com/forums/index.php?topic=8072.0)

I had a similar problem with my front door all setup as RF atm. I use a repeater (NOT a TM751!!) on the same circuit as camera near the front. I have a thick cement wall outside surrounding my house.
you can try first place the sensor in a window (outside) and try.