X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: bmize13 on March 24, 2006, 09:22:30 AM
-
Just curious... Has anyone successfully set up a photo-sensitive light to turn on and off using a wall switch? I have "Dusk to Dawn" lights on my front porch. I installed a motion sensor (MS14A) on the porch, and replaced the wall switch to the light with an X10 switch. I can turn the light on, but not off. The switch does heat up, though... which is different than any of my other X10 switches. I would assume this has something to do with the photocell in the light, but I'm not certain... The flood uses a photocell, and it seems to work.
Any ideas?
-
The Dusk to Dawn light probably uses a triac controlled by the photocell to turn on and off. An X10 wall switch also uses a triac for control and dimming. That is probably the problem as I have a few photocell lights and they say do not use on a dimming type switch. A WS14a with a relay may do the trick for you, but I have never tried it. Also relay type switches need a neutral power wire in the switch box besides the hot and load.
-
The Dusk to Dawn light probably uses a triac controlled by the photocell to turn on and off. An X10 wall switch also uses a triac for control and dimming. That is probably the problem as I have a few photocell lights and they say do not use on a dimming type switch. A WS14a with a relay may do the trick for you, but I have never tried it. Also relay type switches need a neutral power wire in the switch box besides the hot and load.
Thanks. I went ahead this morning and moved the switch on that light to another location and went back to a normal, manual-type switch for the photo-cell lights. I'll have to give this one some more thought.
Thanks again for the answer. I appreciate it!