Hello,
I can connect to the MyHouse service and it works fine for a while. I can view the cameras in my house and change between them. After a while when I switch camera's the MyHouse Status window shows the same command being issued OVER AND OVER. Nothing works after this point. I have to restart the web client machine and the machine at my house in order to get this to stop. If I restart just the web client machine the commands are still being repeated. I suspect its a problem with the AHP USB Module but I'm not sure. I've attached a snapshot o fthe MyHouse status window showing the repeated commands (the Weiner Cam is the camera on my dachshunds ;-).
Any help would be appreciated.
Chris
saddlebear@hotmail.com
Are you using another transciever? that will cause the repeat commands if not configured correctly in your AHP hardware configuration. Is it always the same cam that causes this?
I do have a transceiver in addition to the AHP module plugged in. I forgot all about it. I will remove it and see what happens. Thanks for the reply!!!!!
no problem I had forgoten about mine at one point too! ;)