X10 Community Forum

🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: rucanunes on June 21, 2006, 02:33:33 PM

Title: I really ned help!! Strange problem...
Post by: rucanunes on June 21, 2006, 02:33:33 PM
I have Home Control 1.42 and the PC interface CM11 (USB). I can control all appliences but not lamp modules via PC.
But if I turn on/off some lamp modules via an hand-held remote I can see the state change in the Home Control software.

Can you please give your toughts on this?

Thank you,
Raul Nunes
Title: Re: I really ned help!! Strange problem...
Post by: Charles Sullivan on June 21, 2006, 07:30:41 PM
If you plug a lamp module into the same AC receptacle as the CM11, can you then control it from the PC?