X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: KVF on August 23, 2006, 02:13:59 AM

Title: VCR Comander II Not getting siglal from Floodcams
Post by: KVF on August 23, 2006, 02:13:59 AM

My floodcam security system was working OK.  Would record video when motion was detected.  Now VCR Commander II will only activate VCR when camera is turned on by hand held remote controller.  VCR Commander II will not activate VCR when camera turns on with motion.  Has anyone else had this problem?  Would like some help!    Thanks  KVF.

Title: Re: VCR Comander II Not getting siglal from Floodcams
Post by: Riverineb on March 15, 2007, 03:52:28 PM

Have you solved this problem,
I have 3 floodcams, I can get two to work fine motion and remote, but one will not work with the commander with motion, it will work with remote
any ideas
Gene

Title: Re: VCR Comander II Not getting siglal from Floodcams
Post by: HA Dave on March 15, 2007, 07:17:06 PM

I just replied to that here (http://www.x10community.com/forums/index.php?topic=8204.msg67883#msg67883)

Title: Re: VCR Comander II Not getting siglal from Floodcams
Post by: Riverineb on August 13, 2007, 03:58:30 PM

Quote from: Dave_x10_L on March 15, 2007, 07:17:06 PM

I just replied to that here (http://www.x10community.com/forums/index.php?topic=8204.msg67883#msg67883)

Dave, I cannot get any of the floodcams to activate with motion however, the VCR commander does beep when on home mode.
I can get the vcr commander to activate and I get a picture when I use the remote.  Thats the only time it works ( with the remote).  If the picture is on and working from using the remote and another camera trips all I get is a scrambled screen but the VCR commander with beep with the signal change.
Please help
Gene