X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: KDR on October 23, 2006, 09:52:00 PM
-
I have not tried this but I'm sure someone has...
If you take a motion sensor which has a Unit code + 1 for dusk/dawn and set the unit code to 16 what happens to the + 1 part since theres no 17?
All of mine are in service at the moment AND working so I didn't want to take one down to try it.
-
If I remeber right it sends the unit code 1 ;) :D ;D
-
Just tested a MS14A and Tuicemen is absolutely correct! When the unit code is set to 16, the dusk/dawn transmits unit code 1! ;D
Now I just have to turn my porch light back off. >:(
-
Thanks Tuicemen and Bill. I was expecting that on code 16 dusk/dawn would not operate, not go back to 1. Puts info in memory banks.
-
Yes if it didn't loop around. Unit 16 would be the most popular code if you didn't want to deal with Dusk/dawn ;D