🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: vertexm on October 23, 2006, 11:52:12 PM
Title: TR16 Tone Controller Not Working Properly
Post by: vertexm on October 23, 2006, 11:52:12 PM
About 20 years ago I set up a TR16 controller in my parents weekend home so that the electric heat can be turned on remotely, so the house will be warm when they arrive in the winter. I used an appliance module with another relay to switch the thermostats. The first TR16 I had put in stopped working a few years ago. I replaced it, and it to has worked fine until now. Now, when the phone rings, the appliance module switches on and off with each ring. I thought the TR16 went bad again. I replaced it, but the new one behaves the same. I checked these units at my house, and they seem fine. I could not find anything wrong with the phone line, the off hook voltage seems ok, as does the ringer voltage. Anone have an idea as to what is going on? Once the TR16 answers, it does work normally.
Stumped in NY
Title: Re: TR16 Tone Controller Not Working Properly
Post by: tjdavj on October 24, 2006, 12:47:27 AM
By any chance is it a cordless phone?
If it is then the TR16 or the appliance module may picking up the RF from the phone..
Hope this helps..
Title: Re: TR16 Tone Controller Not Working Properly
Post by: Brian H on October 24, 2006, 07:04:08 AM
Is the problem modules address the House Code and the Third Digit of the Security Code? Example. House Code B Security 1; 5 and 8. The TR16A will cycle on and off address B8. Explained in the users guide as a feature; that could flash a light or lights as the phone rings I have mine cycle a chime module on the house code and third digit of the security code. So any module on the House Code and third digit of the security code will cycle on off as the phone rings.
Title: Re: TR16 Tone Controller Not Working Properly
Post by: vertexm on October 24, 2006, 10:28:33 PM
Brian: You hit the nail on the Head! I just read through the owner's manual, and it doesn't mention this "feature".
Thanks.
Title: Re: TR16 Tone Controller Not Working Properly
Post by: TakeTheActive on October 24, 2006, 11:10:50 PM
Title: Re: TR16 Tone Controller Not Working Properly
Post by: -Bill- (of wgjohns.com) on October 25, 2006, 12:17:39 AM
Yup! That featureis described on page 4 of the manual under INSTALLATION:
7. Set each Module to a Unit Code between 1 and 8. Any Module(s) set to the same number as the third digit on the security code dial (on right) flashes on and off when the phone rings.