X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: tib67 on November 06, 2006, 07:56:22 PM

Title: VCR Commander II Programming Problem
Post by: tib67 on November 06, 2006, 07:56:22 PM
I can not programm a Stop command in to it, it will not work. Anybody with any solution? Thanks
Title: Re: VCR Commander II Programming Problem
Post by: Puck on November 06, 2006, 08:11:05 PM
This is more of a general camera issue than an AHP issue, so if you look in there you will find more info.

Here is a link to one, do as JimC said in his post.

Re: Helpful hints VCR Commander II (UX23A) or UX21A (http://www.x10community.com/forums/index.php?topic=8734.msg58581#msg58581)

The instructions are bad, by correct. (read twice... do once  ;) )