X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: ignis on November 25, 2006, 02:15:04 PM

Title: Brighten Commands with AHP
Post by: ignis on November 25, 2006, 02:15:04 PM

I recently began using AHP and seeing some strang events.

I setup my outside house lights on address K15 and I've set them up to only come on at night. I'm seeing them turn on randomly throughout the day? The odd thing is that AHP tells me they're turning on at only %52

Coincidentally, I have my hallway lights set to K2 and they programmed to brighten by 50% when they see motion. But, when I test them, AHP tells me that the hallway lights were brightened to 52%.

So, my question is... Are my outside lights being turned on when I requesting my hallway lights to turn on? Also, why are they turning on at 52% instead of 50% light I programmed it?

Thoughts?

Title: Re: Brighten Commands with AHP
Post by: steven r on November 25, 2006, 03:59:42 PM

Could be AHP's ghost command bug. Try putting a second or 2 delay after all your dim commands that are not immediately followed by another dim command. There are several discussions of this problem on the forum.

Here's one link. (http://www.x10community.com/forums/index.php?topic=8507.0)