X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: rtc99 on January 23, 2007, 09:29:49 AM
-
I've had and been using x10 for several years now and have all along with my cm15a and AHP been getting the "subject line" message failures. I've been able to keep it to a minimum by adding delays between commands. But after trying X10's SDK command language and executing commands straight from DOS, I can make the failure notice appear after doing a lamp on/off several times. The message says to notify Microsoft of the problem, but don't feel that this is the real problem. Anyone have the same problem and/or fix other than the time delays between commands?
Thanks,
rtc99