X10 Community Forum
🖥️ActiveHome Pro => SDK => Topic started by: EL34 on February 26, 2007, 10:48:40 AM
-
I have successfully blended Hobby Boards 1 wire sensors, Wserver weather program, the X10 Active home pro CM15A USB X10 controller and Perl.
Using the X10 AHP Software developers kit and writing Perl programs, I can control the X10 CM15A USB controller and all my X10 modules based on sensors on my 1 wire network.
Hobby Boards
http://www.hobby-boards.com/catalog/index.php
Arne's Wserver program writes a separate .txt data file to hard disk on every sensor that is detected on the 1-wire network.
http://www.henriksens.net/1-wire/
These Tab formatted .txt data files can be parsed easily, I do it with Perl.
Once the data is parsed you can make decisions and do things in X10 using the X10 SDK.
----------------------------------------
For example:
The crawl space under my house has a Dehumidifier installed to remove excess moisture. Previously, I just let the Dehumidifier run on it's own and make decisions of when to turn on and off. This was ok but not optimum.
I just replace the 3 prong power receptacle that the Dehumidifier plugs into with a X10 appliance module.
I then installed a Hobby Boards 1 wire Humidity/Temp sensor under my house.
Wserver reads the humidity sensor and then appends a new humidity reading to a data file for this sensor every 15 minutes.
I parse the last reading from this data file every 15 minutes.
My Perl script makes a decision to turn on or off an X10 appliance module.
------------------------------------------------------
So far, it is working great.
Now I can dream up new things to control using the Hobby Boards sensors on my one wire network and the SDK.
-
Thank you for all the fine data and work to get it to work.
-
I'll be doing some documentaion on my web site.
I post a link when that is ready.